Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR REMOTE STARTER SWITCH
WARNING:
Before
connecting
Starter Switch, set the transmission
gear lever in the "Park" position for
automatics or "Neutral" position for manual
transmissions and engage the emergency
brake.
NOTE:
It is important to follow the instructions
in the order shown below.
DISABLING PROCEDURE
1. Disable the ignition system as described
under the "Ignition Disabling Procedures"
Section as applies to the type of vehicle
under test.
CONNECTION PROCEDURE
2. Connect the Remote Starter Switch as
shown in the "Connection Remote Starter"
Section. Exercise care when making this
connection because battery voltage is
present at the solenoid or starter relay and
injury could result by shorting the leads.
3. Turn the ignition switch to the "ON"
position before using the Remote Starter
Switch.
CAUTION:
If the vehicle is equipped with an
engine "HOT" indicator, the lamp
test circuit which is in the ignition
system could be damaged if the remote
starter switch is energized with the ignition
switch in the "OFF" position.
the
Remote
4. After the Remote Starter Switch has been
properly connected, push the button. The
engine should crank over.
5. After removing the Remote Starter Switch,
reconnect the leads that were disconnected
during the "Ignition Disabling Procedure"
Section.
The following diagrams illustrate five of the
most common starter relay and solenoid
arrangements and the method of connection
to the remote starter switch.
system you have to one of the diagrams and
follow the individual instructions carefully.
personal injury if shorted to ground through
tools, wires or wristwatch.
E N G L I S H
OFF
ACC
CAUTION:
Battery voltage is always present
at the starter relay or solenoid
terminals
and
Remote Starter Switch
2354
ON
START
Match the
could
cause
5
