GBC Ultima 35 Manual De Instalación Y Funcionamiento página 17

Waves on one side The film is walking during
of the film or lamination due to uneven
media tension
Appearance of Machine is too hot
small dimples
on media and film
(Orange Peel)
Media and film Film is too hot when
have little square exiting the pull rollers on
patterns on the the back of the machine.
output (Checker
boarding)
Gap/Air Pocket Typically found when
between the edge thicker media is used
of the media and
the film (Tenting)
Film curls opposite Film supplies not properly
directions on the matched during
edges as it exits manufacturing process
the back.
Media has curl Film rolls have too much
when lamination tension or drag on them.
complete
Film Rolls have different
amounts of tension
Wrinkles in film as Not enough tension on
the film enters the film rolls
Rollers
Ensure all saddles are closed fully
Try swapping the top and bottom film rolls
Ensure Ready light is on
Confirm proper film thickness selected
Allow machine to cool
Slow down the laminator
Common on longer lamination runs. Try shorter runs or stop to let cool
when present
Try running slower
Ensure ready light is on and proper temperature.
When possible use thinner media
Swap the top and bottom rolls
Clean the film saddles with damp lint-free cloth.
Film rolls should be approximately the same size. Try swapping top and
bottom rolls to change the tension.
Ensure the saddles are fully closed
Clean the saddles with lint-free cloth