Super Ego 300 Manual Del Usuario página 16

GB
Operating instructions
B- The machine continuously stops or starts or
would not start up when the lance is in high
pressure position
- Main cause:
1. Dirt at nozzle or lance outlet
a) IDetach lance (5) from the gun
(8) and in vertical position,
clean lance nozzle with the help
of the tool provided for this
purpose (metallic wire cleaner
included in the instructions
manual) and take it under
running water. In this way, dirt
will completely be removed
from the lance pipe.
b) Using the filter placed at the water inlet
connection (3) is essential.
Filter
2. Dirt built up in the filter. The filter must be
cleaned periodically under a running water tap.
C- Motor stops unexpectedly after continuous
use
- Possible cause: The overheating protection of the
pump has been activated.
- Switch the machine off and let it cool down for
approximately 20min. Then resume operation.
D- Device does not reach the working pressure
Possible solution:
1. Check lance nozzle position: High or low pressure
position. If the nozzle is in the low pressure position
(optimal position to use with detergent), the
machine is running at low pressure.
2. Check whether the filter is clean or soiled. If soiled,
clean under running water. Dirt in the filter prevents
the machine from reaching the water flow rate
required for proper operation. And consequently,
the machine does not work properly.
3. Clean the lance nozzle (5), as it
may be clogged. To this effect,
detach lance (5) from the gun
(8) and in vertical position, clean
lance nozzle with the help of the
tool provided for this purpose
(metallic wire cleaner included
in the instructions manual) and
take it under running water. In
this way, dirt will completely be
removed from the lance pipe.
16