Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Buttons
Press to toggle between the standby and active modes on the
1. Power/Standby
device
button
Cancels the audio coming from the soundbar. Press it again to
2. Mute button
unmute the speaker
Press to start and pause media. This feature is not available in
3.
button
auxiliary mode
Press to select the source device connected via Bluetooth
4. BT button
Press any of these buttons to select the source device connected
5. Aux 1 and
Aux 2 buttons
to the 3.5mm input jack
Press this button to select the source device attached to
6. USB button
the USB port
Press to lower the audio level coming from the soundbar
7. V- button
Press to increase the audio level coming from the soundbar
8. V+ button
Press to go back to the previous track on your play list. This feature
9.
button
is not available in auxiliary mode
Press to select the next track on your play list. This feature is not
10.
button
available in auxiliary mode
IV. Preliminary steps
Wall mount installation
1. The soundbar can be placed on a desktop or hang on the wall.
Caution: Connect any external devices to the soundbar before mounting the
soundbar on the wall.
Before installing the soundbar, make sure it is turned off and unplugged.
Description
2. If you decide to mount the soundbar on the wall, determine the location and
mark the holes on the surface. To do so, check the soundbar hole spacing and
use the supplied brackets as template.
Note: If installing the soundbar below a TV, align the center of the soundbar with
the center of the flat panel.
3. For gypsum or wooden walls, locate studs in the wall. You may use a stud
finder to determine the center of each stud.
4. Using an appropriately sized drill bit, drill a hole in the wall at each marking, and
insert the supplied anchors if installing the unit on a concrete or brick wall.
Tabla de contenido
