Eden World Tour Pro Serie Guia De Inicio Rapido página 9

EDEN | WTP SERIES | WTPPRE REAR PANEL FEATURES - 11
World Tour Pro Preamp Rear Panel Features
1. Output Left: Take your left signal output (post loop) to external equipment here.
2. Output Right: Take your right signal output (post loop) to external equipment here.
3. Aux Input: Connect Auxiliary input signal from your MP3 player or other device using 3.5mm jack cable here.
4. Headphones: Connect your headphones using this 3.5mm input (the headphone volume is controlled by the Master Volume control on
the amplifier front panel).
5. Stereo Loop Return L: Return your left effect chain signal here.
6. Stereo Loop Return R: Return your right effect chain signal here.
7. Balance Control: Use this control to balance the output of the Left/Right line level outputs.
8. Stereo Loop Send L: Send your left effect chain signal out from here.
9. Stereo Loop Send R: Send your right effect chain signal out from here.
10. DI Volume: Adjust the output level of the DI Signal here.
11. Pre-Send: Take your signal from before the EQ stage here.
12. Pre-Return: Return your signal before the EQ stage here.
13. Ground Lift: Use this switch to lift ground on the DI output signal here.
14. Pre/Post select: Select where the DI output signal is taken from here.
15. DI Out: Take XLR DI output signal from here.
16. Tuner Out: Take your signal for your tuner here.
17. Stomp: Connect optional Stompware Eden footpedal here to use footswitchable features on the amplifier.
18. X Over: Turn crossover circuit off or on using this switch.
19. X Over Control: Use this control to adjust the crossover point between the Left/Right line level outputs (Bi-Amp mode only).
1 6 | H I F I D E L I T Y F O R L O W F R E Q U E N C Y
Eden is a part of Marshall Amplification. For more information or to find your regional Eden distributor visit
www.edenamps.com
H I F I D E L I T Y F O R L O W F R E Q U E N C Y | 1 7