Storage; Troubleshooting; Fluid Compatibility; Assembly And Disassembly - Tuthill FILL-RITE FR902R Manual Del Usuario

Storage

If your dispenser is to be stored for a period of time, clean it thoroughly. This will help protect
the dispenser from possible damage.

Troubleshooting

The following troubleshooting guide is designed to help you with basic diagnostics and repairs
if you should encounter abnormal service from your FR902 series dispenser. We recommend
you use only genuine Fill-Rite parts. These parts, and additional service information is
available through your authorized Fill-Rite dealer.
Further troubleshooting information can be found in your pump manual. If you need additional
assistance, please contact us at 1-800-634-2695 (M-F 8 AM–5 PM ET).
Concern
Counter inaccurate.
Fluid leak.
Low flow capacity.
Meter body cracks.
Nutating Disc Broken.

Fluid Compatibility

The FR902 series dispensers are compatible ONLY with the following fluids:
>Diesel Fuel >Gasoline & Gasoline / Alcohol blends (up to 10% ethanol) >Fuel Oil
>Lubricating Oil (up to 60W lubricating oil; not temperature dependant)
CAUTION! If in doubt about compatibility of a specific fluid, contact supplier of
fluid to check for any adverse reactions to the following wetted materials:
Ryton
®
Polyester

Assembly and Disassembly

The FR902 Series Dispenser cabinet contains a 900 series meter, internal plumbing, and
electrical switch. When referencing "Item Numbers" in each procedure, refer to diagram on
page 9 for dispenser item number parts, and the diagram on page 11 for meter item numbers.
Possible Cause
Dispenser mis-
calibrated.
Air in lines or dispenser
chamber.
Measuring gears or disc
are sticking.
Dirty or damaged seal or
gasket.
Clogged meter chamber.
Plugged filter.
Plugged pump.
Excess line pressure.
Sudden high pressure
fluid hitting disc.
Aluminum Stainless Steel
Recommended Repair
Check calibration and recalibrate as
necessary (directions on page 6).
Check line seals and joints for
leakage; seal leaks appropriately.
Clean or replace internal dispenser
components as necessary.
Clean seal or gasket and seat, replace
seal or gasket as necessary.
Clean meter chamber; clean or replace
screens and filters in piping.
Replace filter element.
Inspect and clean pump as necessary.
Install pressure relief valve so high
pressure bleeds back to the tank.
Replace cracked meter body.
Avoid surge flows by installing a shut-
off valve on outlet of dispenser; install
dispenser as close to the pump as
possible, keep piping full of liquid.
Replace meter chamber assembly.
Fluorocarbon
7
Buna N