Tripp-Lite U439-002-CG2 Manual Del Propietário página 5

Offline Cloning Instructions
4. Turn on power to the docking station using the ON/OFF button
on the back of the unit. The red "Power" LED will illuminate to
indicate that power is being received. The red LEDs for drive
bays A and B will illuminate to indicate a hard drive is connected
to the corresponding port and ready for cloning.
Note: Both the A and B LEDs will blink during the cloning process.
5. Press the Clone button for several seconds until the four cloning
LED lights illuminate blue at once.
6. The status LED of 25% will blink when the cloning begins. The
progress bar LEDs will illuminate blue to indicate the percentage
of cloning completed during the process.
7. Once the cloning reaches 100%, all blue progress bar LEDs will
blink blue. The cloning process is complete once the LEDs stop
blinking.
18-09-283-933818.indb 5
5
9/26/2018 12:01:11 PM