Safety Equipment; Pressure Switch; Appliance Switch; Motor Protection Circuit Breaker - Parkside PDR 12 A1 Traducción Del Manual De Instrucciones Original

CAUTION!
Never fill the water tank with solvents, liquids
►
containing solvents, or undiluted acids (e.g.
cleaning agents, petrol, paint thinner, acetone).
They could damage the materials used in the
appliance.
Do not leave the appliance unattended while
►
it is in operation.
Do not leave the appliance unattended while
►
it is connected to the power supply.
Place the appliance on a firm, level surface to
►
ensure stability.
CAUTION!
Do not operate the appliance at temperatures
►
below 0°C.
PDR 12 A1

Safety equipment

CAUTION
Do not change or bypass the safety functions of
►
the appliance. They are there for your safety.
The safety equipment is designed to protect the user and may not be
deactivated or repurposed.

Pressure switch

The pressure switch activates the low-pressure spray jet. When you let go
of the trigger, the low-pressure spray jet stops.

Appliance switch

The appliance switch prevents the appliance from being switched on
unintentionally.

Motor protection circuit breaker

The appliance switches off automatically when the power consumption
becomes too high.

Before use

Operating the appliance on a 12 V circuit

WARNING!
► The current tolerance of your vehicle's wiring system must be
compatible with the connected appliance.
► Refer to your vehicle handbook (cigarette lighter).
♦ Remove the charging socket cover
♦ Connect the correct end of the 12 V cable
on the appliance.
♦ Connect the 12 V connector plug
usually the cigarette lighter socket on the dashboard of your vehicle.
Many vehicles have a second socket by the rear seats or in the boot.
The red LED on the 12 V connector plug
♦ You can now run the appliance on the 12 V socket. Please note that
this does not charge the battery.
♦ Disconnect the 12 V connector plug
when you are finished using the appliance.
♦ Remove the 12 V cable from the 12 V socket
♦ Close the 12 V socket again by replacing the charging socket
cover .

Charging the appliance with the mains adapter

NOTE
► While the battery is charging, the status LED
► When the battery is fully charged, the status LED
► It takes approximately 1 hour for the battery to charge fully when
empty.
♦ Remove the charging socket cover
♦ Connect the end of the charger cable
mains adapter .
5a
♦ Plug the mains adapter into a mains power outlet.
.
to the 12 V socket
with a suitable socket. This is
10a
lights up.
10a
from the cigarette lighter socket
10a
.
lights up red.
lights up green.
.
to the charging socket on the
GB │ MT │
29
■