Mc Haus ARTIC-20 Manual Del Usuario página 41

OPERATION
1. COOL Mode:
• When the appliance enters the cooling mode automatically or the cooling mode is selected
after it has been switched on, the cooling indicator light turns ON.
• Press the Up/Down key to adjust the set temperature (16ºC- 30ºC).
• Press the Speed key to choose High/Medium/Low speed.
2. FAN Mode:
• When the mode key is pressed or Fan mode is selected by pressing the remote control, the wind
indicator light will come on.
• Press the Speed key to choose High/Medium/Low speed.
• The temperature cannot be adjusted.
3. DEHUMIDIFY Mode:
• Pressing
dehumidification mode by pressing the remote
control,
illuminates.
• Remove the dehumidification water wedge, insert
the water trap, place the other end of the water trap
into the water container or drain pipe, as shown in
the figure at right.
• After entering the dehumidification mode, if the
ambient temperature is below 17°C, the compressor
is ON. Then check as follows: when the ambient
temperature is below 15°C
• The temperature cannot be adjusted.
4.TIMER mode :
• In standby mode, press the Timer key to set the ON
time. Press the Up and Down keys to set the power-on time (1-24H), and the timer indicator light
will illuminate.
• In the ON state, press the timer key to set the off time. Press the Up and Down keys to set the power
off time (1-24H), and the timer indicator light will turn on.
DRAIN OPERATION
This product is equipped with an automatic water vaporization system. The
condenser is cooled by the circulation of the condensing water to improve cooling
efficiency and save energy.
If the inner vessel is filled with water, the display will show "FL" and the compressor
will automatically stop working. After turning off the power, unscrew the water
cover, pull out the water wedge to drain the water and the water will become
normal after restarting.
Mc HAUS
the mode key or
the dehumidification
artic-20
choosing the
indicator light
EN