Smoothskin PURE FIT Manual Del Usuario página 12

Always perform a patch test on each new
The patch test area should be approximately 3cm x 2cm in size (equivalent to 2 flashes applied to the
skin side by side). Follow Step 3 to treat the area.
Wait 24 hours following the patch test, to ensure your skin is suitable for treatment and there is no
adverse reaction to the light energy. If there is no reaction after 24 hours, you may treat the area around
the patch test. The 'patch tested area' should NOT be re-treated for at least 1 week.
STEP 3: TREATING WITH SMOOTHSKIN PURE FIT
A) Plug the power supply into an electrical outlet. The fans will start up and the skin tone sensors will
light up blue, indicating the device is switched on.
22
12
11 1
10 2
Observe for
9 24 Hours 3
adverse events
4
8
7 5
6
treatment area
POWER MODE TIMEOUT
When the unit is left "inactive" i.e. no buttons are pushed for 10 minutes then the unit will revert
to STANDBY mode, and the skin sensor lights will switch off. To return to READY mode for
treatment, press the Power Mode button.
B) Press the handset firmly against the area to be treated ensuring the skin tone sensor is in contact
with the skin – SmoothSkin Pure Fit will not operate if the skin sensors are not in full contact with skin.
Once the skin sensor measures a valid skin tone, the pre-set output power is displayed on the power
bars.
Skin contact sensor Treatment window
Skin tone sensor
Indicator On Indicator Off
Skin Detection No Skin Detection
Correct Incorrect
23