Safety Warnings - Perry Electric 1MCD002 Manual De Instalación

PE - DEMCPE005 05/19
PERRY ELECTRIC Srl
Via Milanese, 11
22070 VENIANO (CO)
ITALY
code:
1MCD002

SAFETY WARNINGS!

Read this manual carefully before using the product as it provides important guidelines regarding safety, installation and
&
use. The manual must be preserved with care for future reference. The manufacturer reserves the right to introduce any
technical and/or constructive changes deemed necessary, with no prior notice.
Important: he installation and electrical connection of the devices and appliances must be implemented by person with electrotechnical t
expertise only and in conformity with current laws and regulations. The manufacturer declines all liability in connection with the use of products
subject to special environmental and/or installation standards.
Before starting any operations on the device, disconnect the 230V~ mains power supply
• The Dimmer is suitable for indoor installation and is designed for recessed installation in electrical or 503 junction boxes in walls.
• This equipment will be intended only for use for which it was specifically built. Any other use must be considered misuse and hazardous.
DIMMER VIEW
LED
device status
Holes
for fixing
on the panel;
use ø 4 mm
screws.
Terminals
electrical connection
ELECTRICAL CONNECTIONS
Warning: before performing the electrical connections or any maintenance, cut off the 230V~ mains voltage
L
230V~ 50Hz
N
2 3 4
LS L
P
ELECTRONIC DIMMER
installation in recessed box
The Dimmer is a device to dim artificial light in a domestic, civil and services environment.
It can be installed inside electrical panels, in junction boxes or recessed 503 boxes in walls.
www.perry.it
It has been specifically designed to be used with dimmable lamps: LED, halogen, incandescent
lamps with the "Trailing Edge dimming" (TE) dimming method. ,
The Dimmer has an internal memory and, once the desired light intensity has been set, it will retain
the setting every time it is switched on again.
The connection of remote buttons allows lighting to be controlled in a convenient and handy way, so
that the lights can be switched on and off and adjusted from different points which is particularly
useful in large premises or hallways .
Slots
for device
aeration
(do not
Screws
to tighten
the terminals
(main wiring diagrams)
Do not use backlit buttons max cable length: 100 m
)
TECHNICAL DATA
Supply voltage
Lamp dimming mode
Operating mode LED
Protection degree
Wires section at terminals
Pollution rating
Operating temperature limits
Storing temperature limits
Dimensions
Reference regulations for
CE markings:
close )
dimmable
lamps only
TE
Pmin:
* In accordance with standard EN61000-3-2
**
Check the compatible dimming mode on the lamp packaging,
which must be:
If several lamps are connected to the same Dimmer,
they must be of the same type.
L
N
;
230V~ ±10% 50Hz
TE «Trailing Edge dimming
Red
IP 20
0,75........2,5 mm
normal
0°C ÷ +40°C
-10°C ÷ +60°C
L = 59mm x P = 25mm x H 54mm
LVD / EMC EN60669-2-1
Controllable power
W
10W Pmax: 400W *25
TE
(Trailing Edge).
230V~ 50Hz
2 3 4
LS L
P
ENGLISH
(
» ( Trailing Edge )
2
**
LED
dimmable
Pmin: 10W Pmax: 150W
3