EAS ELECTRIC EMSS178GN1 Manual Del Usario página 24

Correct U se for Your Refrigerator
Warnings
• Don't use mechanical equipment or other methods to accelerate the defrosting process
except the mea ns recommended by the manufacturer.
• Don't use any electrical appliances in the food storage compartments except the model
r ecommended by the manufacture.
• The R600a refrigerant and cyclopentane foaming material u sed in the refrigerator are
inflammable. AII waste and discarded refrigerators shall be placed away from naked fire and
they are not allowed to burn.
New refrigerator is coming
• Remove all packaging material before using the new refrigerator. This includes the foam
base and all adhesive tape holding the refrigerator accessories inside and outside.
• Clean both the inside and outside of the refrigerator with wet cloth (a little detergent could
be added into the warm water to wash the cloth and then wipe it again with the clean water);
• Prepare an independent two-pole socket with grounding contact for the refrigerator and it
shall not share a multi-purpose socket with other electrical appliances;
• Do connect grounding wire! The grounding poi e of the socket shall be provided with a
reliable grounding wire.
• Open the refrigerator body and take out the accessory
{decorative cover for bottom beam) and the three
screws from the instruction packaging bag; then
install them into the bottom beam as shown by
the schematic diagram on the right.
Instruction to height adjustment ofthe door
Before adjusting the height ofthe door, rotate the downward adjusting
nut clockwise (as shown in Figure I) for 2 circles with a wrench,
and loasen the downward adjusting nut. Rotate the upward adjusting nut
(as shown in Figure I) to adjust the height, and then tighten the downward
adjusting nut counterclockwise again.
l.When the door ofrefrigerating chamber is low:
Open the door, use the accompanying wrench to rotate the upward adjusting
nut counterclockwise according to the method as shown in Figure I, to move
it upward until it is parallel and leve!.
2.When the door ofrefrigerating chamber is high:
Open the door, use the accompanying wrench to rotate the upward adjusting
nut clockwise according to the method as shown in Fire I, to move it
downward, until it is parallel and leve!.
Height adjustment cannot be too large. The total
Note:
height can be adjusted to 5 mm!
6 V.1