Baldwin RESERVE SCRAD Instrucciones De Instalación

1. Adjust and install latch
Measure your door backset as shown.
If backset of door measures 2 3/4" (70mm),
adjust latch by rotating face as shown.
LATCH FACE ASSEMBLY
For Drive-In Latch
Remove backplate.
LATCH INSTALLATION
Note, for a 1-1/2" (38 mm) diameter
hole, test if latch extends and
retracts. Chisel out area if required.
U P
Ensure the latch is inserted
with the word "UP" on top.
For Square Corner/
Round Corner
OR
Install with 1/2" (13 mm) screws.
WARNING: This Manufacturer advises that no lock can provide complete security
by itself. This lock may be defeated by forcible or technical means, or evaded by
entry elsewhere on the property. No lock can substitute for caution, awareness of
your environment, and common sense. Builder's hardware is available in multiple
performance grades to suit the application. In order to enhance security and reduce
risk, you should consult a qualified locksmith or other security professional.
Door Preparation
If your door requires drilling, use the supplied template below with the door preparation
instructions available at www.baldwinhardware.com
TEMPLATE
2-1/4"
(57 mm)
1-3/4"
(44 mm)
2"
2-3/8" 60mm
(51 mm)
2-1/2"
2-3/4" 70mm
(64 mm)
Snap on collar.
UP
For Drive-In Latch
Drive in with hammer.
Fold
Doble
Plier
Centerline
Ligne médiane
Linea central
Single Cylinder Deadbolt Installation Instructions
www.baldwinhardware.com • Customer Service 1.800.437.7448
2. Install Trim
Please note: Product illustrations may differ
from your product. Installation is the same.
Not used with
SmartKey products
3. Install Strike
THICK DOOR KIT INSTALLATION INSTRUCTIONS
(AvAILABLE SEPARATELY)
Supports 2" (51 mm) up to 2-1/2" (64 mm) doors
After the completion of Step 1, install the longer torque blade supplied
in the kit. Proceed to Step 2 and install with longer screws.
Remove clip and torque blade.
Install longer torque blade and
reinstall clip to secure.
The drilling template must be printed to scale
to ensure correct hole placement. To confirm
correct print scale, the square below must
measure exactly 1" by 1" (25mm x 25mm).
Copyright © 2011 Baldwin Hardware Corporation
Fits 1-3/4" (44 mm) up to 2" (51 mm) doors
(Thick door service kits for
2" (51 mm) up to 2-1/2" (64 mm) doors
available through customer service)
1/8" pilot holes
may be required.
Do not distort clip.
Ensure clip fits tightly.
1"
25mm
Measure
1"
1"
after printing.
25mm
25mm
47039 / 01