Displaying Stored Results; Deleting Measurements From The Memory - Medicura m246 Folleto De Instrucciones

Then the monitor inflates the cuff until sufficient pressure has built up
for a measurement. Then the monitor slowly releases air from the cuff
and carries out the measurement. Finally the blood pressure and pulse
rate will be calculated and displayed on the LCD screen. The blood
pressure classification indicator and Irregular heartbeat symbol (if any)
will blink on the screen. If the voice function is on, it will announce
the measurement result. The result will be automatically stored in the
monitor.
After measurement, the monitor will turn off automatically after 1 minute
of no operation. Alternatively, you can press the "START" button to turn
off the monitor manually.
During measurement, you can press the "START" button to turn off the
monitor manually.

DISPLAYING STORED RESULTS

Switch the monitor on by using the touch button switch (ON position).
In Clock Mode, press "MEM" button, the last result will be displayed
with date and time. Irregular heartbeat symbol (if any) and the indicator
of blood pressure classification will blink at the same time. Press
"MEM" button repeatedly to review the results measured previously.
If the voice function is on, the monitor will announce each result in
the memory.
When displaying the stored results, the monitor will turn off automatically
after 2 minutes of no operation. You can also press the button "START"
to turn off the monitor manually.

DELETING MEASUREMENTS FROM THE MEMORY

When any result is displaying, keeping on pressing button "MEM" for
three seconds, all results will be deleted after three "beep". Press the
button "MEM" or "START", the monitor will turn off.