Installing Handle Bars & Kickstand; Attaching Blade - Marshalltown SHOCKWAVE SW100H Manual De Instrucciones

Assembly is easy, following these steps:
Step 1 – Remove the 4 hex screws (A) that hold down
the two handle mounting blocks.
Step 2 – Slide kickstand arm onto kickstand end and
fasten with nut & bolt (B) as shown.
Step 4 – Making sure all mounting block and frame holes
are aligned, insert hex screws and tighten with 7/16"
wrench or socket.
Attach blade as shown, making sure the blade is
positioned on the "back side" of the base extrusion with
blade spacers (A) on both sides of the blade.
WS#570
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
ASSEMBLY INSTRUCTIONS
INSTALLING HANDLE BARS AND KICKSTAND
A
B

ATTACHING BLADE

Step 3 – Place handle bars into mounting blocks, making
sure handle bars are centered evenly across the
mounting blocks.
Make sure bolts are tight before each use.
! !
5 of 16