Installation
1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Before installation, ensure that the ange (C)
is placed on the bottom of the new faucet
assembly (A).
Insert the faucet body through
the hole in the sink.
NOTE: This step is for ange installation (optional). If the
ange will not be used, install the faucet assembly as
described in step 2.
A
C
2
Installing the escutcheon
NOTE:
This step is for escutcheon installation (optional).
If the escutcheon will not be used, install the faucet
assembly as described in step 1.
□
Before installation, remove the ange (C).
□
Screw the shanks (F) into the escutcheon (D)
and ensure that the base plate (E) is pressed
onto the escutcheon (D) before the escutcheon
(D) is installed over the three holes in the sink.
□
From underneath sink, secure the escutcheon
to sink with the easy install nuts (G) provided.
Push up the easy install nuts (G) to sink and
hand-turn to tighten, as shown in the Fig 1.
NOTE: If the sink is uneven, use silicone under the base
plate (E).
G
Sink
Push
up
4
D
F
E
Screw
Sink
G
Fig 1
C