Chain Oil - Garland BULK 298 OFE Manual Original

when the chain cools down it will tend to tense and if
too tense it could damage the chain.
New chains need some time until the teeth adapt
and this could modify slightly the length of the chain.
This adaptation takes only a couple of minyes when
in use. If you have just changed the chain, remember
to check the tension of the chain after a couple of
minutes using the machine.

6.3.2. CHAIN OIL

Only use oil specfically recommended for chainsaws.
Do not use already used oils or oils with impurities as
this could damage the oil pump of the machine.
The chain oil must be introduced in the chain oil
deposit.
To avoid dirt and impurities entering the interior of the
deposit, clean the oil cap of the deposit before opening
it.
Close the cap of the oil level and clean if any oil has
fallen outside the deposit.
Check the level of the oil by looking at the oil level
gauge.
Note: The life span of the chain and bar guides depends
on the quality of the oil used. Do not use old or already
used oil! Only use oil that does not damage your
surroundings. Only store oil in homologated recipients.
6.3.3. FIXING THE CABLE
Only use prolongators certified for outdoor use. The
cable section must be at least 1.5 mm
must have a maximum length of 25 m and it must be
completely unrolled before starting to work with the
machine.
Fix the cable by inserting it on the hook provided to
this effect at the back of the machine. Prolongators
longer than 25 m will reduce the working efficiency of
the machine.
6.4. START UP
6.4.1. POINTS TO BE CHECKED PRIOR TO USING THE
MACHINE
The electric current and electric tension must
comply with those on the characteristics label of the
machine. Before starting to work with the machine,
always check the machine works correctly and
securely.
Check the machine and ensure all nuts are tightly
secured, there are no lose pieces. Replace or repair
any broken pieces that you may have seen to be in a
bad state. Ensue there are no oil leakages. Do not use
the machine if damaged or incorrectly regulated.
Only use this machine for those jobs it has been
designed to do. The use of this machine for any other
use is dangerous and could cause damages to you
and/or the machine.
Do not use other accessories this machine except
those recommended by our company since its use
could cause severe damage to the user, people close
to the machine and the machine itself.
Before start up, remove the security blade protector
2
and the cable from the blade.
Check that the moving parts of the machine are not in
contact with any object.
41/156
English