HyLoft TireLoft 01030 Instrucciones De Montaje página 3

Installation time: Approximately 30 minutes.
Important: Read through entire instructions before beginning any installations.
1. Mounting the Upright Supports to the Wall Studs
IMPORTANT: Do not over-tighten the Lag Screws (max 10 ft. lbs.).
They only need to be fully seated, no more. Do not use an impact driver.
Page 3
32"
to 48"
centers
1A:
Using a stud-finder, locate 2
wall studs that are 32" to 48" on
center. Using a pencil, mark the
top mounting hole centers. Make
sure holes are level. Pre-drill the
2 marked holes using a 3/16"
drill bit.
IMPORTANT: Unit MUST be
installed into wall studs. Do not
use wall anchors for mounting
directly to sheet rock.
1B:
Mount the Vertical Tubes of the
Left & Right Brackets (A&B) with
Lag Screws (C), using a 1/2" nut
driver or socket wrench, making
sure holes the are positioned
as shown.
Do not fully tighten the top
screws at this time.
Make sure that the Vertical Tubes
of the Left & Right Brackets (A&B)
are vertically level, then drill
through the remaining 2 holes in
each Bracket (A&B). Fasten with
remaining Lag Screws (C) and fully
tighten all of the Lag Screws (C).