Franke FCRV 908 BK Manual De Uso página 10

4. CONTROLS
Button Function
A Press the button to activate the keyboard and all the lights
come on at half intensity. If the keyboard is not used
for approximately 15/30 seconds it returns to Stand-by.
Press briefly to turn the motor Off.
B Activates speed one.
Press and hold the button for approx. 2 seconds to
Activate/Deactivate the motor in 24h Air Circulation mode,
a speed that allows ducting for 10 minutes every hour,
for a 24 hour cycle. Cannot be activated if Intensive
mode is active.
It is also deactivated when the motor is turned Off.
C Activates speed two.
D Activates speed three.
E Activates Intensive speed. This speed is timed to run
for 6 minutes. At the end of this time the system will
automatically return to the speed set before.
It is disabled by pressing the Button or turning the
Motor off.
F Activates Delay mode, causing automatic shutdown of the
Motor and the Lighting system with a 15 minute delay.
It is disabled by pressing the button.
G
Press briefly to turn the lighting system on and off at
maximum intensity.
Press and hold the button for 2 seconds to turn the Lights
on at intermediate intensity.
H With the filter alarm triggered, press the button to Reset
the alarm. All the Leds will flash 3 times.
Press and hold the button for approximately 2 seconds,
with all the loads turned off (Motor and Lights), to turn
the Activated Charcoal Filter alarm on.
To turn it off, press and hold the button again for 2
seconds.
5. LIGHTING
• For replacement contact technical support
("To purchase contact technical support").
10
Led
-
-
On/Off
Flashing
On/Off
On/Off
Flashing
On/Off
On/Off
On/Off
When the procedure terminates, the indication shown
previously turns off:
C+H Flashing
Indicates that it is necessary to wash the metal
grease filters. The alarm is triggered after the Hood
has been operating for 100 working hours.
D+H Flashing
Indicates that it is necessary to change the activated
charcoal filters and wash the metal grease filters
at the same time. The alarm is triggered after the
Hood has been operating for 200 working hours.
All the Leds flash 2 times.
All the Leds flash 1 times.