Power Down Operation - Leggett & Platt Style Glass Top Manual Del Usuario

Use this procedure to lower the base to flat during a power outage. Do NOT put batteries in power down device until
necessary for use.
Note: Power down device uses 9-volt alkaline batteries, which are not included.
STEP 1
Insert (2) 9-volt alkaline batteries into the power brick (FIGURE 6).
FIGURE 6
POWER
BRICK
INSTALL (2) 9 VOLT
BATTERIES
*BATTERIES NOT INCLUDED
STEP 2
Press the FLAT BUTTON on the remote control or in-line switch (if equipped) (FIGURE 7) to
adjust the base to the level position.
FIGURE 7
ELECTRICAL
POWER CORD
STEP 3
Remove batteries from power brick and discard.
Note: Batteries are good for only one use.
When power is restored from outage, base is ready to resume normal operation.

POWER DOWN OPERATION

BATTERY COMPARTMENT DOOR
(push in and slide up to remove)
IN-LINE
SWITCH
PAIR
BUTTON
5