Personal Protective Equipment; Training - Thermo Scientific ARCTIC Serie Manual De Instrucciones

Section 1 Safety
When using ethylene glycol and water, check the fluid concentration
and pH on a regular basis. Changes in concentration and pH can
impact system performance. 
Ensure the fluid is at a safe temperature (~40°C) before handling or
draining. 
Never operate damaged or leaking equipment, or with any damaged
cords. 
Never operate the circulator or add fluid to the reservoir with panels
removed. 
Do not clean the circulator with solvents, use a soft cloth and water. 
Drain the reservoir before it is transported, and/or stored.

Always turn the circulator off and disconnect the supply voltage from
its power source before moving or before performing any service or
maintenance procedures. 
Transport the circulator with care. Sudden jolts or drops can damage its
components. 
Refer service and repairs to a qualified technician. 
The user is responsible for decontamination if hazardous materials are
spilled. Consult the manufacturer regarding decontamination and or
cleaning agents compatibility. 
Performance of installation, operation, or maintenance procedures other
than those described in this manual may result in a hazardous situation
and voids the manufacturer's warranty and safety compliance. 
Personal Protective
The are no special personal protective equipment requirements needed
to perform normal operation, unless required by the manufacturer of the
Equipment
fluid you are using. Consult their Safety Data Sheet and/or EC Safety Data
Sheet. We do recommend wearing eye protection and gloves.

Training

The user must review and understand all the sections in this manual before
operating the bath.
1-3
Thermo Scientific