Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To switch on the trimmer, press the
01
On/Off switch. To stop simply release
the On/Off switch, (see FIG11).
If you find that the nylon line is
02
too short follow the instruction as in
preparing the trimmer for use' section
2 (see FIG10). Let the trimmer run for
a few seconds without touching the
working area, and allow the trimmer to
cut the line. Use the trimmer at an angle
of approximately 20 degrees to the
working area. (see FIG12). Swing the
trimmer from side to side, (see FIG13).
03
Use the edge of the guard as a guide
when using near fences walls etc, and
move in a backwards direction, (see
FIG14).
04
Do not overload your trimmer, take
small "bites" this will keep machine
operating at high speed and will greatly
improve cutting efficiency, (see FIG15).
TO REPLACE THE CUTTING LINE
To replace the nylon line, first remove the spool cover from the spool holder by
01
pushing down centre of the spool and at the same time pressing the two spool cover
opening buttons firmly, now remove the empty spool and replace with a new pre-
wound spool (see FIG16).
OPERATING THE TRIMMER
Always unplug the trimmer
before carrying out any maintenance.
Press the switch
to turn on, and
release to turn off.
strap
Use in
20° degress
angle.
FIG 13
FIG 11
FIG 12
FIG 14
FIG 15
25
Tabla de contenido
