Installation Steps - MacNeil WeatherTech HPWT01 Instrucciones De Instalación

Installation Steps

Expose 2" (5 cm) of tape liner from each section of Hood Protector. Ensure you can access the free ends of tape liner.
FAR SIDE EDGE
free end
free end
FAR BOTTOM EDGE
NOTE: Some applications do not
3
have side tape by design.
4
Begin removing remaining tape liner, beginning with the drivers side CENTER TOP . Grasping the free end, pull tape gently in 6" (15 cm)
sections, while applying even pressure with hand to Hood Protector. Repeat process for passenger side.
5
NOTE: Do not apply pressure closer than 6" (15 cm) to tape liner as it could accidentally break.
Using the same process, remove tape liner from the driver side CENTER BOTTOM of hood protector. Repeat for passenger side.
6
NOTE: Actual application may vary slightly from illustrations.
NOTE: Inspect part thoroughly to confirm all sections of tape liner are exposed.
Center the Hood Protector on the hood.
CENTER TOP
free ends
free ends
CENTER BOTTOM
Page 2 of 3
FAR SIDE EDGE
free end
FAR BOTTOM EDGE
CAUTION: You must apply even
pressure from center section out to
each end of part, in order for proper
adhesion to hood.
CAUTION: You must apply even
pressure from center section out to
each end of part, in order for proper
adhesion to hood.
free end