INSTALLATION
Select a location to install the receiver base. Mount the
receiver at least 6˝ above the ground using the built-in
keyhole mount. The outlets must be pointed downwards
to prevent exposure to rain. All outdoor devices should be
plugged into a GFCI electrical outlet to prevent electrical
shock. Consult a qualified electrician if your outdoor outlet
is not of this type or you're not sure of its type.
OPERATING INSTRUCTIONS
MANUAL MODE: In Manual Mode, pressing the ON
button on the transmitter will turn on power to the
receiver. Power will stay on until you press the OFF button.
Pressing the OFF button will turn power off to the receiver
regardless of any other mode in operation.
PHOTOCELL MODE: Make sure the sliding mode switch
on the transmitter is in the PHOTOCELL position. Press
the ON button to turn power on to the receiver. All
connected devices will turn on instantly and will turn off
automatically at dawn.
OVERRIDE: You can override any program operating by
pressing the button on the front panel of the receiver
base. Do not hold the button down for manual override
as this will cause the unit to enter Pairing Mode. If you
press the OFF button, the unit will revert back to the last
programmed setting.
