Tabla de contenido
D
Slide the canopy (B) up to the hanger bracket (A)
matching the L-slots on the canopy (B) to the two screws
(MM) on the hanger bracket (A). Turn canopy (B) until it
locks in place.
Insert the two previously removed screws (MM) through
the canopy (B) and into the hanger bracket (A).
Tighten all four screws (MM).
Insert the blade screw (AA) through the blade (F) and the
blade holder (E). Start the blade screw (AA) through the flat
washer (CC) into the hexagon nut (BB). Repeat this
procedure without tightening the screws until all three
screws (AA) have been started into the hexagon nuts (BB).
Once all three screws (AA) are attached, tighten each
screw (AA) securely starting with the center screw. Make
sure the blade (F) is straight.
Repeat these steps for the remaining blades (F) and
blade holders (E).
Fasten blade assemblies (F) to the motor (D) with the motor
screws (HH) and lock washers provided.
Repeat the procedure for the remaining blade assemblies
(F). Make sure all motor screws (HH) are tightened securely.
A
B
BB
E
AA
D
MM
CC
F
F
HH
Tabla de contenido
