Introduction Pre-Install; Network - LiftMaster myQ Business Smart Video Intercom M CAPXM Manual De Instalación

INTRODUCTION
2
Mount CAPXM
1. Attach the goose-neck gasket (provided) if mounting to a goose-neck.
INTRODUCTION
2. Mount the CAPXM securely to a flat surface or pedestal with
appropriate (1/4 in.) hardware taking care to route wiring through
appropriate knockouts. Stainless steel hardware is recommended to
mount the CAPXM. Use of zinc plated or galvanized hardware is at
risk for galvanic corrosion.
NOTES:
INTRODUCTION
-Ensure the cover can fully open to allow access after the installation is complete. Allow 1/8 in. (3.175 mm) of
space between the bottom of CAPXM and the wall, if flush-mounting CAPXM without the trim kit.
-ADA Compliance: When mounting the CAPXM at a pedestrian entrance, to meet ADA compliance, mount the
top of the CAPXM screen no higher than 54 inches from the ground.
PRE-INSTALL
PRE-INSTALL
PRE-INSTALL
Pedestal Mount
INSTALL

NETWORK

INSTALL NETWORK
INSTALL NETWORK
Surface Mount
13
ACCESS CONTROL
DO
Make sure the CAPXM is properly sealed to
prevent damage to the CAPXM from moisture.
ACCESS CONTROL
ACCESS CONTROL