Tabla de contenido
Operating Instructions and Parts Manual
Operating Instructions
During operation, you can start or stop the
release of the detergent or wax by turning the
Detergent Release Valve On or Off (Figure 3).
3. Turn dial on Power Head to desired setting – Jet
or Spray (Figure 4).
4. Install desired attachment. (See below, "Using
Attachments.")
5. Turn on water.
Using Attachments
Important: Rinse polished or fine surfaces before
using attachments on them. As when cleaning
with hand sponges or cloth, it is important to
rinse off loose debris, such as sand, that may
cause scratches.
1. To make the attachments rotate, turn On/Off
Valve (Figure 3).
2. To adjust the rotation speed of the attachment,
turn the dial on the Power Head (Figure 4).
Before turning this dial you must remove the
attachment being used and turn the On/Off
Valve to Off.
– For stronger rotation, set dial to Jet position.
– For rinse action, set dial to Spray position.
3. To use Cleaning Pad or General Purpose Brush
(Figure 5), press either attachment firmly onto
Power Head.
4. To use Gutter/Wheel Brush (Figure 6), press and
twist attachment onto Center Drive Ring. Press
Center Drive Ring firmly onto Power Head.
5. To use a Disposable Sponge (Figure 7), attach it
to Perimeter Drive Ring by aligning three tabs
on Drive Ring with slots on inner rim of Sponge.
To align tabs, look through center of Drive
Ring. After tabs are aligned, turn Drive Ring
clockwise to lock tabs with plastic rim. (NOTE:
Do not use the Center Drive Ring to attach dis-
posable sponge.)
6. To change Power Head angle (Figure 8), turn
On/Off Valve to Off position. Rotate Power
Head and Adjustable Base to desired position.
Turn On/Off Valve to On position.
www.chpower.com
(Cont'd.)
On/Off
Valve
Detergent Release Valve
Figure 3
Jet
position
Figure 4
Power Head
Cleaning Pad
Figure 5
Power Head
Center Drive
Ring
Figure 6
2
PW7010
Off
On
Spray
position
Power Head dial
General
Purpose
Brush
Gutter/Wheel Brush
Tabla de contenido
