Starting The Unit And Handling; Connect The Upper Section Of The Vacuum Cleaner To The Brush Head; Storing And Removing Cable; On And Off Positions - NSS PACER 214 UE Operación Manual

PACER 214 UE / 218 UE
3.1 Connect the upper section of the vacuum
cleaner to the brush head
Unscrew both fastening screws from the upper section of the
vacuum cleaner before assembly.
Push the upper section of the vacuum cleaner upright onto the
brush head. Then insert the two aluminium sections into the
grooves provided on the upper section of the vacuum cleaner.
Fasten with screws. Tighten screws firmly. <Figure 2>
Connect the hose to the brush head and upper section of vacuum
cleaner. Plug the connecting cable with connector into the socket
on the upper section (plug must audibly click into place). <Figure 3>

3.2 Storing and removing cable

The vacuum cleaner's power cable can be wounded up around
the upper and lower cable clips. The entire cable can be easily
removed by turning the lower cable clip.

3.3 On and off positions

The brush head has a pivot latch which locks the unit in the
upright off position. To operate, tread on the latched pedal and
tip the vacuum cleaner backwards. <Figure 4>
Caution: Do not drive the rotating brushes over the connec-
ting cable. Carry the unit over steps and high thresholds.
3.4 Working with the hand pipe <Figure 5>
Switch the unit on via the ON/OFF switch
Please note: The carpet brush switches on automatically
once the hand pipe with handle is firmly located in the motor
housing. Please check.
If the hand pipe with handle is pulled out of the motor housing
for vacuuming, the carpet brush switches off automatically.
The suction hose's elasticity means that the effective working
radius can be increased.
The hose handle can be separated in the middle (bayonett
connection). The crevice and upholstery nozzle can be atta-
ched to both ends.
Important: Never use the hand pipe for vacuuming without
first attaching either the crevice nozzle or the upholstery
nozzle (the cleaner will malfunction if the end of the hand pipe
is worn down – see Section 6 for Troubleshooting).
The hand pipe is pushed upright into the motor housing.

3. Starting the unit and handling

OPERATION MANUAL
Figure 2
Figure 3
Figure 4
Figure 5
7