Singer Stitch Sew Quick Manual Del Usuario página 4

Lower the needle to the fabric and turn the rotating dial
7 ]
until the needle arm is in the highest position again.
Lift the fixing plate and pull the fabric to the left,
8 ]
MAKING SURE THAT YOU DO NOT PULL THE THREAD
TO THE EXTENT THAT IT IS RIPPED FROM THE SEAM.
KNOTTING THE THREAD
Turn the fabric inside out and guide the spare thread
9 ]
of 7.5cm according to the directions stated and the
relevant figures.
Slide the threader down the last stitch. (See Figure #6)
a ]
Thread around 2.5cm of thread from top to
b ]
the bottom. (See Figure #7)
Pass the thread through the loop and pull it tightly to
c ]
tie a knot. (See Figure #8)
Pull out the threader slowly down the stitch.
d ]
(See Figure #9)
Cut off the extra thread.
e ]
THREADING
Note: The thread should flow through the upper right side of
the bobbin or the cone. The spring should be in place before the
bobbin is attached.
Attach the thread to the appliance according to
1 ]
Figures 10, 11 and 12.
Pass the thread through the hole upwards.
2 ]
(See Figure #10)
Figure #9
Figure #10
Figure #11
Figure #12
Figure #13
Correct Incorrect
Direction Direction
Figure #14