Glem Gas GV64TXBK Manual Del Usuario página 40

CLEANING
IMPORTANT:
Always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
2) HOT PLATE
I
t is very important to clean the surface soon after
every use, when the glass is still tepid.
Periodically wash the hot plate, the enamelled stell
pan support, the enamelled burner caps "A", "B"
and "C" and the burner heads "T" (see fig. 6-6/A)
with lukewarm soapy water. They should also be
cleaned plugs "AC" and flame detection "TC" (see
fig. 6). Clean them gently with a small nylon brush
as shown (see fig. 6/B) and allow to dry fully.
Do not wash in the dishwasher.
Do not allow vinegar, coffee, milk, salted water,
lemon or tomato juice from remaining in contact
with the enamelled surfaces for long periods of
time.
Do not use metallic sponges, powder abrasives or
corrosive sprays.
WARNINGS:
Comply with the following instructions, before
remounting the parts:
- check that burner heads slots (see fig. 6-6/A)
have not become clogged by foreign bodies.
- Check that enamelled burner cap "A-B-C"
(fig. 6-6/A) have correctly positioned on the
burner head. It must be steady.
- The pan support must be placed in the
appropriate centering pins.
Verifying the perfect stability.
- Do not force the taps if they are difficult open
or close. Contact the technical assistance
service for repairs.
- Don't use steam jets for the equipment
cleaning.
Note: continuous use could cause the burners to
change colour due to the high temperature.
INSTALLATION
TECHNICAL INFORMATION
FOR THE INSTALLER
I
nstallation, adjustments of controls and
maintenance must only be carried out by a
qualified engineer.
The appliance must be correctly installed in
conformity with current law and the
manufacturer's instructions.
Incorrect installation may cause damage to
persons, animals or property for which the
Manufacturer
responsible.
During the life of the system, the automatic
safety or regulating devices on the appliance
may only be modified by the manufacturer or
by his duly authorized dealer.
3) INSTALLING THE HOT PLATE
C
heck that the appliance is in a good condition
after having removed the outer packaging and
internal wrappings from around the various loose
parts. In case of doubt, do not use the appliance
and contact qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within
children's reach since they could become
potential sources of danger.
The measurements of the opening made in the top of
the modular cabinet and into which the hot plate will be
installed are indicated in either fig. 7. Always comply
with the measurements given for the hole into which
the appliance will be recessed (see fig. 7).
The appliance belongs to class 3 and is
therefore subject to all the provisions
established by the provisions governing such
appliances.
40
shall not be considered