C. Reduction
1.
Put the fine middlings recovered from the
breaking 1 and 2 and sizing operations in the
sizing/reduction hopper.
2.
Select Reduction cycle by clicking on the icon
on the control tablet and start it by clicking on
and then on
.
3.
When the cycle ends, recover the material
from drawers H and I and weigh them. Note
the weights and carefully keep each product
separate.
4.
Put the fine middlings recovered from the
reduction (drawer I) operation in the sizing/
reduction hopper.
5.
Select a new reduction cycle by clicking
on the icon
and then
6.
When the cycle ends, recover the material
from drawers H and I and weigh them. Note
the weights and carefully keep each product
separate.
It is possible to perform one or two additional steps by repeating operations 4 to 6.
CLEANING THE DEVICE
It is recommended to clean the drawer compartments using a
vacuum cleaner at least once a week. Do not use the vacuum
cleaner in the sieve / beater compartment. There is a risk of
damaging the parts.
SWITCHING OFF THE DEVICE
1.
To shut down the device, click on the icon
2.
The next screen is displayed. Click on the icon
3.
To start the device up again, press the button located
between the screen and the emergency shutdown
button.
POWER DOWN
1.
To shut down the device, click on the icon
2.
The next screen is displayed. Click on the icon
3.
Shut down the LabMill by switching off the ON/OFF
button at the back of the device.
Reduction block diagram
(steps 4 & 5)
1
.
4
.
.
.
.
2
5
1
2
1
2
3
3
3