Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Step 1: Check the parts
required for the
installation
1
Before you get started, have on
hand a Phillips screwdriver and
the appropriate screws (at least
six M8 (or equivalent) screws,
not supplied), depending on the
material of the wall.
2
Open the package and check the
parts.
Supplied accessories
Name
Plate Unit
Mounting Hook Unit
Hook
Screw
M5 × L16
• For hook attachment (4)
• For securing mounting
hook unit (2)
Mounting Hook Unit
Securing Screw
M6 × L20
Step 2: Decide on the
1
Decide on the installation
location. The installation
location should be a
perpendicular and flat wall.
Display dimensions are shown on page 11.
Allow for suitable clearance between the Display
Unit and the ceiling and protruding parts of the
wall as shown below.
Unit: mm (inches)
Quantity
100
(4)
1
WARNING
The wall that the Display Unit will be installed on
should be able to support a weight of at least four
times that of the Display Unit (page 11).
Determine the supportable weight of the wall
before installing the Display Unit. If the wall
2
cannot support the weight of the Display Unit,
reinforce as necessary.
Note
If you intend to route the cables behind a wall, make a
hole in the wall to insert the cables. The positions for
4
the cable holes are shown in the diagram on page 12.
2
Determine the positions of the
screws and the cable hole (if you
6
intend to route the cables
behind the wall) by referring to
the diagram on page 12.
2
installation
location
US
100
(4)
5
(US)
Tabla de contenido
