Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. CENTERING
THE TABLE
a. Loosen the four hex.,bolts mounting the table to the upper table
trunnion. (See Fig. 7)
FIG, 7
b, Move the table sideways as required, until the saw blade runs
through the center of the table insert.
c. ft the adjustment of "b" is not enough to center the table, loosen
!he four flange nuts holding the lower table trunnion and move the
tabie sideways to place the table in the center.
d. Re-tighten hex. bolts for trunnion, recheck the saw blade
position.
2. SETTING
TABLE
SQUARE
TO SAW BLADE
Loosen the wing nut on the lower table trunnion and place a
suitably sized square against the saw blade. If the table requires
adjustment,
proceed as follows:
a. Using a wrench, release the hex. nut on the frame. (See Fig.8)
b. Place the wrench on the hex. bolt and adjust until the table
square to the saw blade.(See Fig.8)
FIG. 8
c. Tighten the hex. nut and recheck the saw blade and the table for
squareness.
d. Lock the table into position and check that the indicator reads
zero degree on the side of lower table trunnion. Loosen the screw
securing the indicator and reset if necessary to give zero degree
reading. (See Fig. 9)
3. TILTING
THE
TABLE
For bevel cuts, the table tilts 0 through 45 degrees.
a. To tilt the table, loosen the wing nut on the table trunnion, set the
table to the required angle and tighten the wing nut again (See Fig.
10).
FIG. 10
b. It is recommended
to verify the correct angle setting using an
angle guide, or by making trial cuts in scrap wood.
Adjust the
indicator accordingly by using a phillips head screwdriver.
4. ADJUSTING
THE RIP FENCE
The locking pressure of the rip fence has been factory-set, if
adjustment
is required proceed as follows:
a. Raise the fence handle to horizontal position.
b. Turn the fence handle clockwise to increase clamping pressure,
counterclockwise
to decrease clamping pressure.(See
Fig. 11)
c. After counterclockwise
truning the fence handle, sliding the rip
fence to the desired position on the guide raiL(See Fig. 11)
d. The fence handle has a cam action, press down the handle to
stamp tightly to the table after setting rip fence to desired position.
I
FIG. lt
NOTE:
Do not adjust the fence handle such that excessive
pressure is exerted during operation - this may lead to deformation
of the end clamp at the rear of the rip fence. Set the fence handle to
apply just enough pressure to enable safe operation during
cutting.
5. CHANGING
AND ADJUSTING
THE SAW BLADE
This bandsaw is factory-equipped
with a general-purpose
wood
cutting blade, the saw blade is set prior to delivery.
To change the saw blade, the following procedure must be
followed:
WARNING:
To avoid injury from unexpected starting, whenever
changing the saw blade or carrying out adjustments, switch the
handsaw off and remove the power cord from the main outlet. To
avoid injury to hands when handling the saw blade, wear gloves
whenever necessary.
6
Tabla de contenido
