STIL 6040 Consejos De Uso página 19

Guidance and declaration of manufacturer-electromagnetic emissions
The device is intended for use in the electromagnetic environment specified below.
The customer or the user of the device should assure that it is used in such an environment.
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/ flicker emissions
IEC 61000-3-3
Guidance and declaration of manufacturer-electromagnetic immunit
The device is intended for use in the electromagnetic environment specified below.
The customer or the user of the device should assure that it is used in such an environment.
IMMUNITY test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrostatic
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
IEC 60601 test level
± 8 kV contact
±2 kV,±4 kV,
±8 kV,
±15 kV air
± 2 kV for power supply
lines
± 1 kV for
input/output lines
± 1 kV
differential mode
± 2 kV
common mode
Compliance Electromagnetic environment-guidance
Group 1 The device uses RF energy only for its internal
function. Therefore, its emissions are very low
and are not likely to cause any interference in
nearby electronic equipment.
Class B The device is suitable for use in all establishments,
including domestic establishments
and those directly connected to the public
low-voltage power supply network that supplies
buildings used for domestic purposes.
N/A
N/A
Compliance level Electromagnetic environment-guidance
± 8 kV contact Floors should be wood, concrete or ceramic tile.
±2 kV,±4 kV, If floors are covered with synthetic material, the
±8 kV, relative humidity should be at least 30 %.
±15 kV air
N/A
N/A
19