Control Panel - FEBREZE FHT170 Serie Instrucciones De Uso

INSTALLING THE FEBREZE
• Insert scent cartridge completely into
the scent compartment. IT WILL ONLY
FIT IN THE AIR PURIFIER ONE WAY.
• Close the Scent Compartment door
• Set the scent control dial to adjust scent
intensity for personal preference
When the foil seal is removed or partially
removed, from the scent cartridge, the
fragrance oils will be exposed to the air and will
start to evaporate. Once the foil layer has been
removed, you must use the scent cartridge in
the air purifier or dispose of it. It cannot be re-
sealed and saved for re-use later.
NOTE: The air purifier will also function without using a scent cartridge.
Control Panel
• Once the filter and scent
cartridge are installed, plug
the air purifier into a working
electrical outlet.
• Make sure you have selected
the desired scent intensity.
• Turn the Cleaning Level
Control Dial to the desired
cleaning level:
III = High, II = Medium, I = Low
A green LED will illuminate to
indicate that the unit is
powered "ON".
The unit will start up at the
High speed.
Portable air purifiers are more effective in rooms where all doors and windows are
closed. In general, it is recommended that you run your air purifier while you are at
home to clean the air.
6
SCENT CARTRIDGE (cont.)
™
OPERATION
Cleaning Level
Scent Control Dial
Control Dial
Power Indicator
Light
ELECTRONIC FILTER AND SCENT CHECK REMINDERS
This Febreze™ Air Purifier has electronic filter
and scent check reminders. There is a FILTER
RESET button and a SCENT RESET button on
the control panel with a red LED light next to
each. Based on hours of use, the red LED will
illuminate when it is time to replace the filter
and/or the scent cartridge. It is recommended
that the air filter be replaced every 4 months
and the scent cartridge will last up to one
month. When the recommended time period has elapsed the red light will come on as
a reminder to replace the filter or the scent cartridge. The red LED(s) will remain on until
the Filter or Scent button is RESET. You may unplug the air purifier without interrupting
the filter or scent check.
You should periodically check the filter. Depending on operating conditions, the filter may
need to be replaced more or less frequently. One scent cartridge will last up to 30 days,
depending on desired scent intensity and operating speed. You may replace the scent
cartridge more or less frequently than the recommended 30 days.
To RESET the Electronic Filter or Scent Check
When the filter or scent check lights remain on, it is time to replace the filter or scent
cartridge and RESET the filter or scent monitor. The old filter or scent cartridge should be
removed and new ones installed.
Reset the Filter monitor.
• Install a new Febreze
• With the unit powered on, press the
FILTER RESET button next to the red
LED and hold for approximately 2
seconds until the light turns off.
Reset the Scent monitor.
• Remove old scent cartridge and
dispose of properly
• Install new Febreze
• With the unit powered on, press the SCENT RESET button next to
the red LED and hold for approximately 2 seconds until the light turns off.
Early Reset Option
Scent Cartridge
Compartment Depending on your individual usage (environment and hours used), you may wish to
replace the filter or scent cartridge BEFORE the red indicator light turns on. If this is
the case, you will need to do an early RESET. To do this, press the Filter Reset or Scent
Reset button and hold for approximately 5 seconds to illuminate the red LED, then press
the Filter Reset or Scent Reset button again and hold for approximately 2 seconds until
red LED light turns off. This will cause the usage cycle time to restart again for 4 months
for the filter and 1 month for the scent cartridge.
Scent Cartridge
indicator light
U Air Filter
TM
Scent Cartridge
Reset Button
Air Purifier Scent Cartridge
TM
Filter change
indicator light
Filter Reset Button
7