Troubleshooting - Juiceman The Big Apple Manual Del Usuario

4. To clean the food pusher, twist to unlock and remove the small food pusher
from the large food pusher. Clean with other removable parts; once parts are
dry, put back together.
5. To clean the feed chute, remove the feed chute hatch release cover and use the
cleaning brush to remove any small particles of food stuck on the feed chute
hatch mechanism.
6. To clean the filter, use cleaning brush provided to make sure tiny holes in
mesh filter are not clogged. This can be accomplished by holding filter under a
running faucet while brushing the mesh filter screen from both the inside and
outside of the filter mesh with the cleaning brush.
Important: The cutting blades at the bottom of the filter are extremely sharp!
Always hold and carry the filter by the rim.
REMOVING TOUGH STAINS
1. Due to powerful staining properties found in many vegetables, particularly
carrots, we suggest soaking any stained parts overnight in one of the following
solutions:
• Biodegradable soap in enough warm water to cover juice extractor parts
• ¼ cup bleach added to a sink full of warm water
• 1 part warm water to 1 part cider vinegar
• ½ small box of baking soda in enough warm water to cover juicer parts
Important: Never use ammonia or abrasive cleansers!
2. After soaking overnight, lightly scrub with soft bristle brush and liquid
detergent.
STORAGE
Store your appliance in a clean, dry place. Never wrap cord tightly around the
appliance. Do not put any stress on cord where it enters juicer, as this could
cause cord to fray and break.


TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
Juice extractor is turned Safety lock may not
on but will not run. be closed securely.
Appliance makes loud Soft foods may
noises and begins to have clogged the
vibrate. filter.
Motor seems to stall. Juicing may be too
vigorous and/or
pulp has built up
under the cover.
Pulp is too wet and not May be pushing
enough juice is being foods too quickly
extracted. through the
appliance.
Juice leaks between the Juice pitcher may
juice pitcher and the cover not be properly
of the juice extractor. placed.
Juicing action may
be too fast.
OVERHEAT PROTECTION SYSTEM
Important: This appliance contains a PTC overheat protection system. When
the appliance is being operated for too long or with too much load, the PTC
protector will shut down the power of the appliance to protect the unit. If the
power shuts down, unplug for  minutes and plug in for normal operation.
SOLUTION
Turn appliance to OFF (0)
and unplug. Check that
each part of appliance is
attached correctly and all
parts are clean and free of
food remnants.
Turn appliance to OFF (0)
and unplug. Remove the
filter basket and clean with
a brush to remove all food
particles.
Turn appliance to OFF (0)
and unplug. Remove the
filter basket and clean
with a brush to remove
all food particles. Clean
cover before replacing and
continuing to juice.
Use the pusher as a guide;
do not use pressure.
Turn appliance to OFF
(0) and unplug. Remove
the filter and clean with a
brush to remove all food
particles. Soak the filter
in a solution of hot water
and lemon juice (this will
remove excess fiber from
the strainer) or wash in
the dishwasher on the top
rack.
Make sure juice pitcher is
flush with the appliance.
Slow down the juicing
action.