PAPILLON 96849 Instrucciones página 20

Cod. 96849-99176
d)
Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous in the
hands of untrained users.
e)
Maintain power tools, Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f)
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g)
Use the power tool, accessories and tool bits etc., in accordance with these instructions and
in the manner intended for particular type of power tool, taking into account the working
conditions and the work to be performed. Use of the power tool for operations different from
intended could result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
ADDITIONAL SAFETY RULES FOR LAWN MOWER
Read the instructions carefully. Be familiar with the controls and the proper use of the appliance.
Never allow children to use the appliance.
Never allow people unfamiliar with these instructions to use the appliance. Local regulations may restrict
the age of the operator.
Never operate the appliance with people, especially children, or pets are nearby.
The operator or user is responsible for accidents or hazards occurring to other people or their property.
While operating the appliance, always wear substantial footwear and long trousers. Do not operate the
appliance when barefoot or wearing open sandals.
Thoroughly inspect the area where the appliance is to be used and remove all stones, sticks, wires,
bones, and other foreign objects.
Before using, always visually inspect to see that the rotating parts and cutter assembly are not worn or
damaged. Replace worn or damaged parts in sets to preserve balance.
Operate the appliance only in daylight or in good artificial light. Avoid operating the appliance in wet grass,
where feasible. Always be sure of your footing on slopes. Walk, never run. Always work across the face
of slopes, never up and down.
Exercise extreme caution when reversing or pulling the appliance towards to you.
Do not operate the appliance on excessively steep slopes.
Use extreme caution when reversing or pulling appliance towards you.
Stop the rotating parts if appliance has to be tilted for transportation. Do not operate the cutting means
when crossing surfaces other than grass, and when transporting the appliance to and from the working
area.
Never operate the appliance with defective guards or shields, or without safety devices, for example
deflectors and/or catchers in place.
Switch on the motor according to instructions and with feet well away from rotating parts.
Do not tilt appliance when switching on the motor, expect if the appliance has to be tilted for starting. In
this case, do not tilt it more than absolutely necessary and lift only the part, which is away from the
operator. Always ensure that both hands are in the operating position before returning the appliance to
the ground. Do not put hands or feet near or under rotating parts.
Never pick up or carry an appliance while the motor is running.
Pull the plug from the socket:
Whenever you leave the machine.
Before clearing a blockage.
After striking a foreign object. Inspect the appliance for damage and make repairs as necessary.
If the appliance starts to vibrate abnormally, check immediately.
When the machine is at work in the thick bushes or runs into obstacles it can't cut down, the blade will be
stalled so that the machine temperature and current will increase. When the temperature is too high or
the current is too large, the overload protection device installed inside the machine will automatically shut off the power to stop the machine ( main purpose is to protect motor and prolong motor life ). At this
moment, let go of the trigger and disconnect power supply of the machine, let the machine cool in some
time ( 1~2 mins) and then restart switch, the machine can rework.
Symbols
The rating plate on your tool may show symbols. These represent important information about
the product or instructions on its use