Charging A 12 Volt Battery - Pulsar PG4500iSR Manual Del Operador

Charging a 12 Volt Battery

This generator can be used to charge a 12 volt automotive or storage battery by
taking the following steps:
Inspect fluid level of the battery cells (if applicable). Add ONLY distilled water to any cell
where fluid level is low. Never add tap water.
1. Use a wire brush to clean battery terminals if corroded.
2. Securely connect the red cable clamp to the positive (+) battery terminal.
3. Securely connect the black cable clamp to the negative (-) battery terminal.
4. Turn the Economy switch to the "OFF" position when charging battery.
5. Battery is considered fully charged when the voltage is at or above 12.7vdc,
when measured by a volt meter.
Note:
It is strongly recommended to check battery voltage level at least once per hour with a volt meter
to prevent overcharging and to test the battery's condition.
WARNING!
• Do not disconnect battery clamps while charging. Batteries produce and vent explosive gasses. Disconnecting
the battery clamps while charging could cause a spark and lead to a fire.
• Do not charge any battery in an enclosed area.
• Never smoke while charging the battery or operating or fueling this generator.
•
Battery electrolyte contains sulfuric acid. Avoid contact with skin, eyes, and clothing. Always wear eye protection
when charging battery.
• lf battery acid contacts skin, flush with water immediately. If it contacts eyes, flush with water for 15 minutes and
get immediate medical attention. For internal ingestion, drink large quantities of water or milk, followed by milk of
magnesia, beaten egg, or vegetable oil. Contact a medical physician immediately.
OPERATION
Battery electrolyte is poisonous and dangerous.
15