Maintenance - AIR8 720i EDGE Manual De Instrucciones

4.
Configure
You can edit the name of the device within the App.
From the Dashboard you can control your device remotely:

Maintenance

1. Cleaning the pre-filter
Cleaning the pre-filter:
• Please ensure the product is switched-off and unplugged before proceeding.
•
Disconnect the power cable from the device.
•
Open the backside grid by pulling it out slightly and then lifting it up in order to
take it out completely.
•
Rotate the 2 dark grey fixtures by 90 degrees in the direction indicated by the
arrows.
•
Take out the filter set using the handle.
• Take out the pre-filter carefully using the 2 plastic
•
Vacuum-clean the pre-filter.
•
Return the pre-filter by inserting the slats into the filter frame. The 2 plastic tabs
shall face outwards.
•
Install the filter set back into the
•
Rotate the 2 dark grey fixtures 90 degrees to secure the filter
•
Place back the backside grid and connect the power cable to the device.
Cleaning the air sensor:
•
Please ensure the product is switched-off and unplugged before proceeding.
•
Disconnect the power cable from the device.
•
Locate and open the dust sensor panel door located on the side of the device.
• Use a vacuum cleaner to clean the dust sensor door.
• Use a cotton-swab to softly clean the dust sensor.
• Close the dust sensor panel door.
and control your device remotely
device.
tabs.
set.
11