SUNDAY York Crystal Instrucciones Para El Montaje página 7

ASSEMBLY, USE AND MAINTENANCE
Dear customer,
Thank you for choosing a SUNDAY® product: a high quality product that, when assembled and used accord-
ing to the instructions contained in this manual, remains resistant to strains caused by weather conditions over
a long period of time.
A) ASSEMBLY INSTRUCTIONS
Materials required for assembly: SUNDAY® BETONFAST® high elasticity glue for masonry or another high
elasticity. We recommend that you use BETONFAST® glue as it guarantees the highest level of performance
and safety in comparison with other products on the market. It also allows you to dismantle the components if
necessary.
Read the warnings shown on the glue packaging carefully before use.
It is absolutely prohibited to use any type of glue other than those indicated above. These include, for
example, high resistance and quick hardening cements (white cement, aluminous cements, refractory
cements or tile glue). This is because these types of glue do not allow thermal expansion of the elements,
producing a tension that may cause components to crack or in some cases break.
1. Check that the correct number of components is included and that they are intact. If any components are
missing or faulty do not use the product. Request a replacement component before beginning to assem-
ble the product.
2. You MUST position the table on a cement support base that is able to support the weight of the table. The
base must be perfectly level with completely fl at surfaces. If the product is to be fi tted on a terrace or simi-
lar structure it is essential that you check the fl oor capacity with a specialist prior to installation.
This product must not be cemented / glued to the ground / base.
3. PAY ATTENTION when removing the packaging straps as components may fall and cause damage to
persons and objects.
4. Glue the components to each other to secure them and make them completely stable, following the num-
bering shown in the diagram. Do not exceed the amount of glue indicated. This is to avoid creating areas
that are too resistant to expansion, particularly in the area of the combustion chamber. A strip of glue be-
tween two adjoining surfaces is suffi cient.
5. Once all the operations have been completed, wait at least 24 hours before using the product.
NOTE: some effl orescence (white stains) can sometimes appear as calcium hydroxide moves to the surface
and combines with carbon dioxide in the atmosphere. These natural blemishes can be simply washed off using
water and a soft brush. It may be necessary to perform this operation several times.
Colour shades may vary due to the natural colouration of materials used. Therefore, differences in colour
shades between components/ products made from the same material do not constitute grounds for complaint.
The product was designed to be used as a table/bench. Any other use is absolutely forbidden.
To protect the product and any accessories made of wood or steel as much as possible from atmospheric
agents during winter or when not in use, you are advised to cover it with a sheet of waterproof material to pre-
vent premature deterioration (these are available in various sizes from the SUNDAY® accessories catalogue).
ALL RESPONSIBILITY IS DECLINED FOR FAILURE TO COMPLY WITH ALL OR PART OF THE INSTRUC-
TIONS CONTAINED IN THIS DOCUMENT. NO FORM OF GUARANTEE SHALL BE RECOGNISED FOR
ANY SUCH FAILURE.
In accordance with standards in force, the warranty covers the replacement of faulty individual parts
and NOT THE ENTIRE PRODUCT.
Final notes:
Sizes are indicative and may be subject to variation.
Wooden parts of the packaging, cardboard, polystyrene and the plastic sheet must be taken to appropriate
material recycling centres. To not disperse these materials into the environment.
7
GB