DELETING A CHANNEL FROM THE MOTOR
NOTE:
Removing a remote or channel from a shade does not delete or reset the limit settings.
1. Select the channel you'd like to disconnect the shade from.
2. Press the Confirm button repeatedly (about 3 - 7 presses); the shade will jog three individual times. After the
third jog, your channel is removed from the shade, and ready to be assigned to a new channel or a new remote.
ADJUSTING UPPER AND LOWER LIMITS
NOTE:
The upper and lower limits are already set-up at the factory, so the following steps
are only necessary if you want to change how these settings are configured. Both limits
must be reprogrammed in these instructions.
1. Start with the shade fully raised. For a few seconds, press and hold the Limit button
until the shade jogs. Your motor is now in programming mode.
2. Press Down to lower the shade until it's almost to the bottom, then press Stop. From
here, repeatedly press Down to lower the shade slowly.
3. When the shade reaches the desired bottom position, flip the remote and use your pen
to press the Confirm button. The shade will jog to acknowledge that your lower limit is now
set, but the motor is still in programming mode.
4. Press Up to raise the shade until it's almost to the top, then press Stop. From here,
repeatedly press Up to raise the shade slowly.
5. When the shade reaches the desired top position, flip the remote and use your pen to
press the Confirm button. The shade will jog to acknowledge that your upper limit is now
set, and the motor will automatically exit programming mode.
SETTING A FAVORITE POSITION (OPTIONAL)
1. Start with the shade raised fully, then press the Down button for the shade to lower.
2. Press Stop at the position you wish to save as your favorite.
3. Simultaneously press and hold the Limit button and the Up button, until the shade
jogs. Your favorite position is now set. If you wish to change the favorite position,
simply repeat these steps again.
®
Simple. Smart. Custom.
INSTALLATION GUIDE | ROMAN SHADES
C
S
BY BF
C
L
S
T
CONFIRM
BY BF
C
L
(C)
S
T
CONFIRM
BY BF
C
L
(C)
S
T
LIMIT (L)
BY BF
C
L
S
T
UPDATED MAY 2021
CONFIRM (C)
BY BF
L
T
LIMIT (L)
4