Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OUTSIDE MOUNT
1. Measure 2"- 4" in from each side of the window frame. From here, measure
upward another 2" - 4", and make a pencil mark.
NOTE:
Leave marks for any additional brackets you need, evenly spaced between
your first two marks and at the same height.
2. Center the top edge of the brackets on your marks. With your pencil, mark
through the back holes of the bracket. This is where your screws will go.
3. At each of your marks, pre-drill holes with a 5/64" drill bit.* Align each bracket
with your screw holes and drill the screws securely into place.
*If you are using wall anchors, pre-drill with a 1/4" bit instead, and tap the wall
anchors into the holes with a hammer before drilling in the screws.
ATTACHING THE SHADE
2.
INSIDE AND OUTSIDE MOUNT
NOTE:
For outside mount, use your level to check that the brackets are
straight before you proceed.
1. With the front of the shade facing you, and holding it at a slight
downward-angle, rest the lip of the headrail against the movable tab
in each of the brackets. Then gently push it toward the back of the
brackets, while also straightening the rail, until the hooks attach to the
back lip of the headrail.
MOUNTING THE TENSION DEVICE
3.
CONTINUOUS CORD LOOP SHADES
NOTE:
The cord tension device, also known as the "chain tensioner," is used to
help protect pets and young children from a potential choking hazard. If there is
plastic or any protective bands on the chain, remove them before proceeding.
1. Raise your shade fully so it's out of the way.
2. Pinch the ends of the tensioner together to release the grip on the chain, then
pull the tensioner to the bottom of the chain loop.
3. While keeping the chain pulled tightly, place the tensioner against the inside
of the window or on the wall, moving it up about 1/8 of an inch. The goal is to
make the chain taut but just slightly loose for smooth operation.
4. Holding the tensioner in place, mark the two screw holes with your pencil.
Move the chain away and use the marks to pre-drill your screw holes with a
5/64" drill bit.
5. Align the holes in the tensioner with the pre-drilled holes and fasten the
screws, being careful NOT to over-tighten the screws.
6. To use your shade, simply pull the front of the chain to raise it, and pull the
back of the chain to lower it.
®
Simple. Smart. Custom.
INSTALLATION GUIDE | ROMAN SHADES
TAB
HEADRAIL
SCREW
HOLES
INSIDE MOUNT
OUTSIDE MOUNT
2" - 4"
CHAIN
UPDATED MAY 2021
2
Tabla de contenido
