Factory Setting - san ignacio 00182 Manual De Instrucciones

cator light turns off. Standby mode will be
removed.
If you want to return to standby, repeat
steps 1 and 2 again, with the difference that
the one cup button light will stay on after
pressing.
DESCALING MODE
1 Place a cup in the water spout.
2. Put an adequate amount of descaling de-
tergent in the water tank.
3. Hold down the button for a cup and con-
nect the appliance to the mains.
4. The power button and the one cup button
will remain lit. Press the one cup button to
start the descaling function. The machine
will stop automatically after 120 seconds.
If you want to stop descaling, press the one
cup button again.
ADJUSTING THE AMOUNT OF COFFEE
Once in "coffee" mode, press and hold the
button for one cup or two cups (depending
on whether you are preparing one or two
cups) until you obtain the desired amount
of coffee.
It can be pressed for a minimum of 10 sec-
onds and a maximum of 90 seconds.

FACTORY SETTING

Hold down the two-cup button and insert
the plug of the appliance into an outlet.
The indicator light on the buttons will blink
twice, which means the machine will have
returned to the factory default settings.
IMPORTANT NOTES
1. After a long time without use, the ma-
chine may have some water pumping prob-
lems. Follow these steps to manually fill the
internal system of the coffeemaker with
water. If necessary, the procedure should be
repeated 2-3 times. After this, the machine
will be able to pump water normally:
- Set the "hot water" function.
- Remove the water tank. Place the tube in