IMER KOINE 35 Manual De Uso, Mantenimiento Y Repuestos página 28

INCONVENIENTI
Machine does not start Acqua
Water pressure too low: the gauge shows pressure below 2 bar (green lamp on?), the
display shows the text H
Machine does not start Material
- Product too dry in mixing chamber
(mortar pump seized? red lamp on?)
Machine does not start Air
- The air pressure, with jet valve completely open, does not fall below the minimum pres-
sure value on the machine pressure switch (table 1)
Machine does not start Electrical current
and compressor does - No current delivered to connector of site panel
not start and the blue (fuses?)
light is OFF - No power delivered to machine
(defective connector connection? loose cable?)
- Main switch not ON
Machine does not start Electrical current
but compressor starts - Start selector switch not in correct position
- Mixing chamber open
(start/stop pushbutton lamp on?)
- Mortar pump motor connector not inserted
(start/stop pushbutton lamp on?)
- Low water pressure switch trips on start-up
(water pump switched on ?see also "machine does not start due to water)
Cell wheel does not Material
start - Material hardened in hopper
- Material too compact in hopper
(machine moved with hopper full?)
Mortar pump and/or cell Electric current
wheel does not start
(red lamp illuminates after a few seconds?)
- Motor faulty
- Faulty cable
- Faulty connector
Machine does not stop Air
and/or compressor - Air hose defective
does not stop (hose cut? Air leaks from couplings?
- Compressor air supply low
- Jet air valve faulty (blocked in open position)
Machine stops after Water
starting up -
- Water hose too long and/or too narrow
IMER INTERNATIONAL S.p.A.
KOINE 35
CAUSE
O
2
29
RIMEDI
- Check that water is delive-
red from the supply hose
is clean
- Check that the water pump
is switched on
- If the pump collects from a
tank, check that it has been
primed and there are
no leaks from couplings
- Initial start-up not performed
correctly (see para.11)
low (see para.11)
- No water delivered to
mixing chamber
(water inlet obstructed,
water solenoid valve mal-
function)
- Check that the air hose is
not bent or obstructedo
- Check that the jet nozzle is
perfectly clean
- Check points listed
alongside
- Check points listed
alongside
- Check that water does not
continue to enter the mixing
chamber when the
machine is stationary
- Empty hopper (see para.11)
- Ensure that the electric
cable section is adequate
(see para.10.1)
- Check the current line to
the site panel and site panel
connector
- Check motors, electric
cables and connectors
- Check the air hose and
couplings in particular and
replace if necessary
12)
- Check compressor relief
valve
- Check points listed alongsi-
water hose (at least 10-12
l/min if working with lime-
cement based plaster, at le-
ast 15-20 l/min with gypsum
based plasters) and replace
hose if necessary or collect
water from an auxiliary tank