Troubleshooting; Corrective Action - Kobalt KPC 2040-06 Manual Del Usuario

TROUBLESHOOTING

PROBLEM
Gun and/or hose
leaks.
Unit won't spray.
Wand/Nozzle
Gun
Hose
The machine does
not start.
POSSIBLE CAUSE
1. Loose connection.
2. O-ring is missing or
damaged.
1. Power or water supply
is not on.
2. Hose, gun, wand, or
nozzle is clogged.
Wand/nozzle is clogged
or spraying pattern is
uneven.
Gun is clogged.
Hose is clogged.
The battery is not
charged.
Battery is too cold.

CORRECTIVE ACTION

1. Tighten the connections.
2. Turn off and depressurize the unit. Disconnect,
remove, and replace old o-ring.
1. Turn power or water supply on.
2. Consult troubleshooting list below for these specific
parts and instructions.
Turn off and depressurize unit. Remove wand/nozzle
from gun outlet. Look through the opening in wand;
you should see light through the nozzle end. If not,
then reverse flush with air or water to dislodge debris.
Turn off and depressurize unit. Remove wand from
gun and gun from hose. Reverse flush the gun with air
or water to dislodge debris.
Turn off and depressurize unit. Remove gun from
hose and hose from unit. Flush the hose with air or
water to dislodge debris.
Charge the battery by following the procedures in the
battery and charger manual.
Remove battery from unit. Place battery on charger
and allow to charge for 10 minutes or until the
changing light turns green. Remove from charger and
install in unit for use.
13