Runpotec RUNPOMETER RM35 Instrucciones De Uso página 13

GUIDE FOR A MEASUREMENT
1
2
Open the lid of the RUNPOMETER with the
and install the guide jaws
measured and close the instrument lid. Align cable start flush with front housing
surface. Note the index mark (arrow)!
Reset the measured value to 0 (hold RES button
Pull the cable slowly and evenly by hand to the desired length/length to
be measured. Read off the measured value/cut the cable, the front housing
surface is the index mark
Index mark
– Arrow marks front housing surface of the device as measuring
5
reference (start/end point for measurement).
USING THE GUIDE JAWS
Select guide jaws for the respective cable diameter according to the table be-
low. Insert in pairs, with the selected diameter facing up, into the holes provided.
Cable cross-section
Ø 2 – 6 mm
Ø 7 – 12 mm
Ø 13 – 18 mm
Ø 19 – 24 mm
Ø 25 – 32 mm
USE OF ACCESSORIES SYSTEM CASE MOUNTING PLATE
1 2
The RUNPOMETER RM35 can be attached to the RUNPOTEC system case for
stationary operation by means of a mounting plate.
1 Open the folded system case mounting plate by pressing the red button.
2 Place on case, engage to case on one side.
3 Fix the system case mounting plate on the other side with the red case
locking mechanism. (Fold the red locking mechanism up).
4 Insert/engage the device into/in the holder provided for this purpose.
To remove the device: press the red button, remove the device.
See page 4 – 5 for further application examples
RUNPOTEC GmbH – Irlachstrasse 31 – A-5303 Thalgau
Tel.: +43-6235-20 335 – Fax: DW 35 – [email protected]
1
(see Using the guide jaws). Insert the cable to be
2
5
Guide jaws
Ø 6 mm – red
Ø 12 mm – grey
Ø 18 mm – grey
Ø 24 mm – red
Without guide jaws
3
ENGLISH
locking button on the side. Select
down for 3 seconds).
D
4
13
5
 
x x