Tools And Materials; Before You Begin - Kohler K-9486 Manual Del Usuario

Ocultar thumbs Ver también para K-9486:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before
you start installation. If you encounter any installation or performance problems, please don't hesitate to
contact us. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler
Company.

Tools and Materials

Drill
Safety
Glasses
Claw
Hammer

Before You Begin

Observe all local plumbing and building codes.
Locate the rough plumbing for the drain in accordance with the roughing-in dimensions for your
particular model.
A variety of installations are possible. These instructions show suggested installation procedures,
your particular installation may require other construction techniques.
Please read these instructions carefully to familiarize yourself with the required tools, materials, and
installation sequences.
Your shower receptor comes packaged in a single carton containing a one-piece shower receptor.
This carton will fit through any standard door. You should not remove the receptor from the
package until you are ready to install it.
Unpack and inspect the shower receptor for damage. If you find any damage, do not install the
receptor. Report the specific problem to your dealer immediately.
After inspection, return the shower receptor to the carton until you are ready to install it.
The shower receptor must be installed to an adequately supported, level subfloor.
Before installing the stud framing for the shower receptor, locate a 2" (5.1 cm) diameter drain pipe
that extends 3/8" (1 cm) above the subfloor.
Make sure the installation area is clean and free of all debris. If remodeling, remove all finished wall
material to expose the framing and remove all floor coverings to expose the subfloor.
Provide properly dimensioned framing.
This shower receptor is designed for an alcove installation.
The exact location of the end studs will depend on the thickness of the finished wall material.
1058614-2-B
Screwdriver
Pipe
Square
Wrench
Pencil
Tape
Measure
Knife
2
Level
Silicone
Sealant
Plus:
• Common Woodworking
Tools and Materials
• Nails/Drywall Screws
• Drop Cloth
• 2x4's or 2x6's
• Water Resistant Wall Material
• Furring Strips
Plumbers
Putty
Kohler Co.
Tabla de contenido
loading

Este manual también es adecuado para:

K-9488K-9489K-9496

Tabla de contenido