Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Installation precautions
R Do not install the camera on a ceiling.
R Do not install the camera in areas directly
exposed to water or rain.
R Holes must be made in the wall for cables
and wires to pass through. Panasonic takes
no responsibility for issues related to
opening holes in walls.
R Make sure to waterproof the holes you
make in the wall.
R Make sure you attach the safety wire to
prevent the camera from falling.
R Do not use an impact driver. (This may lead
to damaged screws or over-tightening.)
R Mount the camera on the stable location
where the unit can be adequately
supported when installing.
R The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of
the adaptor may cause it to become
disconnected.
R Do not mount the camera on a soft
material. It may fall down, break or cause
injury.
For assistance, please visit www.panasonic.com/support
Wall material information
Siding
R Use the included screws ø4 mm ´ 25 mm
(ø5/32 inches ´ 1 inch). Make sure the
pull-out capacity of each screw is at least
294 N (30 kgf).
R If the weight of the camera is supported by
the siding only, the siding could become
damaged. Make sure you mount the
camera in a location where the structure
behind the siding can be used to support
the weight of the camera. If this is not
possible due to the thickness of the siding,
use commercially-available screws ø4 mm
´ longer than 25 mm (ø5/32 inches ´ longer
than 1 inch).
R Drill a pilot hole using a drill bit that is
appropriate for the type of siding. Remove
any debris after drilling the pilot hole. Do
not drill the pilot hole into the structure
behind the siding.
Poor example
No support behind exterior surface
1
Siding
2
Open space, no support
Setup
2
1
17
Capítulos
Tabla de contenido
