Pre-Run Inspection; Batteries Replacement For Satchel; Using The Sprayer - Kärcher PS 4/7 Bp Electrostatic Instrucciones De Funcionamiento

Pre-Run Inspection

1. Check all fittings and connectors for proper
assembly.
2. Check all hoses for leaks. Repair or replace any
damaged hoses.
3. Remove tank lid and add pre-mixed chemical to
chemical reservoir.
4. Remove nozzle and prime pump by spraying back
into tank for 10 sec.
5. Replace nozzle on gun and lid on tank.

Batteries Replacement For Satchel

The sprayer satchel uses two 1.5v AA batteries.
The end user can choose to use 1.5v alkaline batteries
or 1.5v lithium batteries. Lithium batteries are
recommended as they will provide longer life and better
performance. Do not mix used or different types of
batteries. Replace all batteries at the same time.
Install/remove the batteries using the retention cap
located at the bottom of the satchel.
Install the batteries negative end first.
WARNING: Keep away from small children. If swal-
lowed, promptly see doctor phone (202) 625-3333
collect.
WARNING: Battery can explode or leak and cause
burns if installed backwards. Do not open battery,
dispose of in fire, heat above 100degC (212degF),
expose contents to water, recharge or mix with
used or other battery types. These conditions may
cause personal injury.
WARNING: Avoid charging as lithium iron disulfide
batteries are not designed to be recharged.
8.644-870.0 - Manual Operators PS 4-7 Bp Electrostatic

Using the Sprayer

WARNING: To avoid personal injury, basic PPE
(gloves, mask, foot and eye protection) must be
worn.
1. The sprayer can be used in either normal direc-
tional spray mode or in Electrostatic spray mode.
2. Attach strap clips to satchel.
3. While operating the sprayer, the satchel should be
worn over the shoulder or across the chest.
Operation
9