Electrical Safety; Safety Warnings - Rehau RE.GUARD Indicaciones De Seguridad

About this documentation
This document is an extract from the Technical Information
EN
„RE.GUARD water control" (no. 410600). There you will find
further information on RE.GUARD water control.
Pictograms and logos
The following pictograms and logos are used in this
document:
Safety notice
Legal information
Important information to note
Current version of the manual
For your own safety and in order to ensure correct application
of our products, please check regularly whether an newer
version of this document is already available. The issue date
of your document is printed on the bottom right of the back
page.
You can view and download the current document and more
instructions under www.rehau.com/ti.
Intended use
The RE.GUARD water control is only allowed to be installed
and operated as described in the technical documentation
„RE.GUARD water control" (no. 410600). Observance of these
instructions is part of the intended use.
Installation and maintenance are only allowed to be carried
out by suitable and trained specialist personnel. These
personnel are authorised and enabled by training and
experience as well as instruction to carry out the
corresponding installation work, to recognise and avoid
possible dangers and to observe the relevant applicable
regulations (e.g. regulations on work safety, electrical safety
etc.)

Safety warnings

Ignoring the instructions can cause injury or property
damage.
No liability is accepted for damage caused by non­observance
of the instructions.
If you do not understand the safety warnings or individual
instruction steps, or find them unclear, please contact REHAU
(see inside back cover).
6
Prevention of accidents
Observe the applicable national and international routing,
installation, accident prevention and safety regulations and
the instructions in this document when installing piping
systems and components of the drinking water installation.
Laws, standards and regulations
Observe the applicable laws, standards, guidelines,
regulations (e.g. DIN, EN, ISO, DVGW, NEN, VDE and VDI) as
well as regulations on environmental protection, regulations of
the trade associations and regulations of the local supply
companies.
The installation of the RE.GUARD water control
system is a major change in the drinking water
installation and, according to most national regulations,
may only be carried out by an installation company
registered in an installer register of a water supply
company. Please check these national regulations
before installation.

Electrical safety

Risk of death due to electric shock
In older buildings, check whether the metallic water
pipe is used as earthing for the electrical installation. A
domestic water meter bridged with cable would be a clear
indication of this.
Ensure alternative grounding before disconnecting the pipeline.
Work on electrical equipment is only allowed to be performed
by authorised and qualified electricians. Unauthorized and
improper work can result in fatal electric shock.
Transport and storage
Store RE.GUARD water control in closed packaging and only
remove it immediately prior to installation.
Do not expose the device to frost or heating above 50 °C
during transport and storage.